Artem Sizing Guide: Loop-Less Sailcloth Strap

Find Your Perfect Fit

You'll need at least two measurements to choose an Artem strap that fits perfectly: the width (18mm, 19mm, 20mm, etc.) and the length (short, regular or long). If you plan to swap the buckle for a different buckle or deployant clasp, you'll also need the strap/buckle taper.

Strap width

On a wristwatch, lug width determines strap size. "Lug width" refers to the distance between the two projections that hold your strap in place, as shown.

Measure your lug width using a metric ruler or a caliper. The width must be in millimeters (not inches), and it must be a whole number (18mm, 19mm, 20mm, etc.). The strap size will match the lug width. If your lug width is 20mm, select a 20mm strap.

Strap length

To determine your strap length, you'll need your wrist measurement in inches.

Using a flexible tape measure or a strip of paper, wrap your wrist where your watch would naturally sit. Mark the point where the two ends meet.

If using a paper strip, use a ruler to measure it (in inches). That number is your wrist size.

We sell Artem's Loop-Less straps in two lengths: Regular (Artem's Standard) and Short (Artem's XS).

Note: If you are in between sizes, go the next length up.

Strap/buckle taper

The strap/buckle taper is important information if you're swapping out the buckle. Artem's straps taper in width toward the buckle as shown:

Your buckle width matches the width at the buckle end of the strap, not the lug end.

Example:

Artem's 20mm strap tapers to 18mm at the buckle. For this strap, you would select an 18mm deployant clasp or buckle. A 20mm clasp will be too big.

Any questions? Contact us and we are happy to help.