How to Measure for an Artem Loop-Less Watch Strap
Find Your Perfect Fit
You'll need at least two measurements to choose an Artem Loop-Less Standard or Loop-Less HydroFlex strap that fits perfectly: the width (18mm, 19mm, 20mm, etc.) and the length (short or regular). If you plan to swap the buckle for a different buckle or deployant clasp, you'll also need the strap/buckle taper. These steps will help you measure watch strap size accurately and ensure a comfortable, secure fit.
Strap Width
On a wristwatch, lug width determines strap size. "Lug width" refers to the distance between the two projections that hold your strap in place, as shown.
Measure your lug width using a metric ruler or a caliper. The width must be in millimeters (not inches), and it must be a whole number (18mm, 19mm, 20mm, etc.). The strap size will match the lug width. If your lug width is 20mm, select a 20mm strap.
Strap Length
To determine your strap length, you'll need your wrist measurement in inches.
Using a flexible tape measure or a strip of paper, wrap your wrist where your watch would naturally sit. Mark the point where the two ends meet.
If using a paper strip, use a ruler to measure it (in inches). That number is your wrist size.
We sell Artem's Loop-Less straps in two lengths: Regular (Standard) and Short (XS).
Note: If you are in between sizes, go the next length up.
Strap/Buckle Taper
The strap/buckle taper is important information if you're swapping out the buckle. Artem's straps taper in width toward the buckle as shown below.
Your buckle width matches the width at the buckle end of the strap, not the lug end.
Example: Artem's 20mm strap tapers to 18mm at the buckle. For this strap, you would select an 18mm deployant clasp or buckle. A 20mm clasp will be too big.
See our full watch strap size guide for more details on measuring and fitting your watch strap. Need more help selecting your strap? Contact us. We’re glad to assist.
